Pro-M Question

[thickstunalexndr]

I am redoing the entire intake in my car. One of the mods is a Pro-M MAM. Is there a shop around here that can tune the air/fuel ratios through the MAM and run this on the dyno? Would I be looking around $300 for this?

[AirCowboy]

save the 300 for euro taillinghts and neon lights

[Ponyperformance6]

You can get a Wide-Band O2 pull done down at that new shop where Ed did his dyno. I am sure they can tune it there for you as well. If not call superchips up and they will be able to do a custom chip for you with your car on the dyno if you like.

[thickstunalexndr]

save the 300 for euro taillinghts and neon lights

I'm not sure dude, I was gonna buy that big ass wing so my ass end won't slide everywhere as I'm going down the quarter :)

[thickstunalexndr]

You can get a Wide-Band O2 pull done down at that new shop where Ed did his dyno. I am sure they can tune it there for you as well. If not call superchips up and they will be able to do a custom chip for you with your car on the dyno if you like.

Will or Ed...Is there a phone # so I can reach these guys? I'm pretty interested. Someone told me that the pro-M is already calibrated...will I still be able to squeeze off an extra few horses by tuning it further (since it's probably not calibrated for the TB and plenum)?

[Ponyperformance6]

I'm not sure dude, I was gonna buy that big ass wing so my ass end won't slide everywhere as I'm going down the quarter :)
I pray you are joking :whoa: