Kurt: Steeda Susp. Parts Install

[HeloPilot]

Kurt,

I just ordered the following parts and was wondering if I was going to have any trouble with the install:

-Rack Bushings
-Sway Bar Bushings
-Sway Bar Billet mounts
-End Links
-Bump steer kit
-X2 Ball Joints


Any advice or guidance would be appreciated.

Rich

[4U 2 NV]

not many ball joints are "easy" to put in.

add alignment to that list.

[HORSEpower]

The sway bar bushings are a pain in the ass to put in. YOu have to do some cutting. All the sway bar stuff is easy to do. The ball joints aren't that bad. You will definately need an alignment after all that.

Kurt

[HeloPilot]

I was planning on the alignment...the problem is, I have to find a shop in this po-dunk place that can do the alignment with my CC plates and the bump steer kit(there are some extra needs with the bumpsteer).

Kurt, you said the "sway bar bushings are a pain in the ass" and then said "all the sway bar stuff is easy to do". Which do you mean? Any advice on the PITA part?

Rich